How to Eliminate Corrosion From Stained Glass

Corrosion on stained glass is commonly referred to as white mold. It seems on the guide or solder lines, leaving the stained glass piece noticed and unattractive. The corrosion or white mould is usually the consequence of flux residue that was not thoroughly taken out.
One particular method utilised to take away the corrosion is to scrub the art glass piece with cleanser. This will eliminate the corrosion, but it may also lead to scratches on the glass.
The ideal way I have discovered for taking away the corrosion is to use baking soda. Baking soda is not as abrasive as cleanser and will not scratch the glass.
You will need a little scrub brush or very fantastic steel wool. Very first dampen the scrub brush or metal wool with water. Then liberally sprinkle baking soda over the piece. Using the dampened scrub brush or metal wool, scrub the glass piece vertically, horizontally and in a round motion.

As soon as all the corrosion has been scrubbed off, totally rinse off the baking soda and dry the art glass piece. If the piece had a patina finish, you might have to re-patina the piece. This will count on how a lot corrosion had accumulation on the piece.
After the piece is entirely dry, use a finishing compound to shield and polish the artwork glass piece.
This method performs really effectively, although it takes time, operate and reapplying finishes. If you have a stained glass piece with corrosion, you truly do not have a option. For long term reference, you can steer clear of corrosion from occurring by correctly taking away flux when setting up your up coming piece.
The widespread cause of corrosion is flux. By no means go away flux on a piece for much more than a number of hrs. There are a selection of industrial flux removers that you can use. Be sure to stick to manufacturers’ instructions.
I have located CJ’s to be a very good industrial flux remover. Subsequent manufacturers’ instructions, I liberally spray CJ’s on a single side of the glass piece. Using a gentle scrub brush, I scrub the glass in a round movement, then, rinse the piece with h2o. Then, subsequent the same procedure, do the other facet.
residential glass repair
Making use of baking soda and dish cleaning soap is an alternative for commercial flux removers. Initial, sprinkle the piece with baking soda, then implement a little sum of dish cleaning soap to the piece. With a comfortable, moist scrub brush use a circular movement to scrub the piece. Rinse with water and then do the other side.
After the piece has been cleaned and rinsed with water, pat the piece dry with a comfortable cleanse fabric and permit it air dry. Once it is completely dry, patina can be applied. The final stage is to use ending compound to the two sides.

Leave comment

Your email address will not be published. Required fields are marked with *.